Fun To Do Deep Black Resin
3D Printing resin Fun To Do Deep Black.
Deep Black is an high resolution 3D printing resin.
With only a 0.5 % shrinkage it is a perfect choice for with artistic prints. It has the look and feel of injection moulded plastic. As Fun To Do team state “When we say black, we mean black, deep black, with no discoloration in even the finest detail. Because of the very small, near nano particle pigmentation, ‘Deep Black’ has an ultra-high definition,”
- Agitate in a vat of Isopropyl Alcohol (IPA), for 2 minutes to remove excess resin. Use a soft brush if necessary.
- Clean off any excess IPA with a cold blowdryer or compressed air.
- Leave under the sun or in a UV lamp to cure. The resin is sully cured when fingernails do not leave scratch marks on the object.
Store the resin in a dry, cool, shaded place out of direct sunlight.
Do not soak in IPA or water (the resin is hydrophobic). Do not place in an ultrasonic bath.
More information is available at FunToDo.
3D printing resin Fun To Do Deep Black characteristics
|Viscosity||at 25°C||80 mPa.s|
|Hardness (Shore D)||81|